2015 1(16)

Back to table of content

   Short abstract

 

Pages:

195 - 199

Language:

RU

Ref.:

7


Click to get extended abstract


Download paper: [RU]

2015_1(16)_37.pdf

 

 

PLASMA GASIFICATION OF CARBON-BERING WASTE

Messerle V.E.1,2, Mosse A.L.3, Ustimenko A.B.4,5

1Институт проблем горения МОН РК, Almaty, Kazakhstan
2 Institute of Thermophysics SB RAS, Novosibirsk, Russia
3 A.V.Luikov Heat and Mass Transfer Institute of NAS of Belarus, Minsk, Belarus
4 Scientific Research Institute of Experimental and theoretical physics of AL-Farabi Kazakh National University, Almaty, Kazakhstan
5 STU "Plazmotekhnika", Almaty, Kazakhstan


Citation:

Messerle, V.E., Mosse, A.L. and Ustimenko, A.B., (2015) Plasma gasification of carbon-bering waste, Modern Science: Researches, Ideas, Results, Technologies, Iss. #1(16), PP. 195 - 199.


Keywords:

plasma; synthesis gas; biomedical waste; plasma torch; furnace chamber; processing


Abstracts:

This paper presents a thermodynamic analysis of the plasma processing of Biomedical Waste (BMW). It is shown that the final products do not contain toxic substances. From the organic mass of BMW synthesis gas was basically produced, and mineral part consists mainly of calcium oxide and contains no carbon. Linear DC plasma torch of 30 kW nominal power was created. From the obtained current-voltage characteristics of the plasma torch parameters of its stable operation are defined. According to the results of experimental studies modes of the plasma furnace chamber are identified, the analysis of the exhaust gases is prepared, samples of the condensed products are selected in the chamber and their chemical composition is determined. The plasma processing of BMW can be used in medical, pharmaceutical and biomedical institutions. The obtained synthesis gas can be used as fuel for power generators based on a new generation of solid oxide fuel cells.


References:

  1. Brunner C.R., Brown C.H. Hospital waste disposal by incineration. Waste streams, technology, and state requirements // Journal of the Air Pollution Control Association (JAPCA). - 1988. - Vol. 38, N 10. - P.1297- 1309.

  2. Mosse A.L., Savchin V.V. Modelirovanie protsessa pererabotki mediko-biologicheskikh otkhodov v plazmennoy kamernoy pechi // Inzhenerno-fizicheskiy zhurnal. - 2006. - T. 79. - N 4. - S. 12-16.

  3. Gorokhovski M., Karpenko E.I., Lockwood F.C., Messerle V.E., Trusov B.G., Ustimenko A.B. Plasma Technologies for Solid Fuels: Experiment and Theory. // Journal of the Energy Institute. - 2005. - Vol. 78. - N 4. - P. 157-171.

  4. Mosse A.L., Savchin V.V. Plazmotermicheskaya pererabotka toksichnykh otkhodov // TBO - Tverdye bytovye otkhody (nauchno-prakticheskiy zhurnal). - 2006. - N 12. - S. 22-24.

  5. Mosse A.L., Gorbunov A.V. , Sauchyn V.V. Plasma furnaces for toxic waste processing // Journal of High Temperature Material Processes, An International Quarterly of High Technology Plasma Processes. - 2006. - Vol. 11, Issue 2. - P. 205-218.

  6. Zhdanok S.A., Mosse A.L. Plasma methods for Toxic Wastes Processing // Plasma Assisted Decontamination of Biological and Chemical Agents. Springer Science + Business Media B.V. - 2008. - P. 143-149.

  7. Galvita V., Messerle V.E., Ustimenko A.B. Hydrogen production by coal plasma gasification for fuel cell technology // International Journal of Hydrogen Energy. - 2007. - Vol. 32, Issue 16. - P. 3899-3906.

 

 
     

© SPIC "Kappa", LLC 2009-2016